Special Stud
Welding Equipment

Table Top CD Stud Welding System

Weight: 115 Lbs.
Table Size: 22” Wide 18” Deep 24” High (Max. Ext.)

CONSTRUCTION:
Table Top: Cast Aluminum
Base: 16 Ga. Steel Painted
Front Panel Controls: Two Palm Type Weld Buttons. Adjustable Pneumatic Controls For: Weld Pressure
Additional Control: Time Delay before weld
(no delay in gap mode)		 Welding Materials: Steel, Stainless, Aluminum, Copper, Brass
Welding Diameters: Dependent on Power supply/Controller used for welding.
Weld Mode: Contact / Gap
Polarity: Straight or Reverse
Requirements: 120 Volt AC 50/60 Hz 10 amp
Air Requirements: 80 PSI, Filtered and dry air

NOTE: Full flanged studs are recommended for use with the Table Top Welder. The unit uses “B”,
(.375 Dia. ) Collets and Stops.

Gravity drop CD Stud Welding System

Weight: Varies (depends on work size)
Table Size: Varies (depends on work size)

CONSTRUCTION:
Table Top: N/A
Column: Extruded aluminum channel (adjustable)
Front Panel Controls: Two Palm Type Weld Buttons. 
Additional Control: Time Delay before weld
(no delay in gap mode)		 Welding Materials: Steel, Stainless, Aluminum, Copper, Brass
Welding Diameters: Up to 3/8" aluminum CD with Proweld Gravity Drop power source.
Weld Mode: Gap
Polarity: Straight or Reverse
Requirements: 120 Volt AC 50/60 Hz 10 amp
Air Requirements: 80 PSI, Filtered and dry air

NOTE: Full flanged studs are recommended for use with the Gravity Drop Welder. The unit uses standard adjustable chucks.