ARC-800
The
ARC-800 is a compact and portable stud welding power supply capable
of welding studs through 1/2” diameter weld base. The power
supply which operates on single phase power has the added feature
of weld current regulation that improves stud welding consistency.
Both the weld time and weld current are infinitely adjustable
for preciseness and repeatability. A specially designed electronic
gun control circuit has been incorporated to increase overall
reliability. If a fault condition occurs due to a shorted gun
solenoid or a faulty control cable, the circuit will prevent
gun retriggering and eliminate damage to printed circuit boards.
|
ARC-1200
The
ARC-1200 is a compact and portable stud welding power supply
capable of welding studs thru 5/8” diameter weld base. The
fully regulated power supply which operates on three phase power
produces a smooth, stable welding arc. Both the weld time and
weld current are infinitely adjustable for preciseness and repeatability.
For maximum flexibility the weld time can be switched between
two ranges. The expanded short time range provides fine adjustment
of weld time for special short cycle applications such as welding
to thin materials. |
ARC1850
The
ARC-1850 is a fully regulated stud welding power supply that
is available in a single or dual gun version. Both versions have
the constant output feature that allows the unit to be used as
a power source that can operate external stud welding control
units. Stick welding and Arc air gouging processes are available
only as an option. An added feature in the ARC-1850 is the ability
to dial in the desired weld time and weld current before even
making a weld. By selecting the setup mode, the weld time and
current can be adjusted and displayed on the front panel digital
meters. It is capable of welding studs from 12ga to 7/8”
diameter with preciseness and repeatability. |
ARC-3000
The
ARC-3000 is a fully regulated stud welding power supply that
is available in a single or dual gun version. Both versions have
the constant output feature that allows the unit to be used as
a power source that can operate external stud welding control
units. An added feature in the ARC-3000 is the ability to dial
in the desired weld time and weld current before even making
a weld. By selecting the setup mode, the weld time and current
can be adjusted and displayed on the front panel digital meters.
It is capable of welding studs from 1/4” to 1-1/4”
diameter with preciseness and repeatability. |
